Which PDO threads will be superior for straightening eyebrows and lifting lip corners

[Deleted member 1078]

Tagging @Clavicular and @Orc

Especially clavicular boyo if you could respond because I've seen your video with some old roidcell and your eyebrows definitely got straight as hell I suspect you did it

I have purchased PDO threads - bidirectional cogs , mono and spiral ones

For straightening eyebrows and lifting lips up I suppose id shall I just insert bidirectional ones from the above eyebrow/lips and go down with the needle then just pull up.

Just this is what makes the most sense , spirals and monos don't seem fit for that purpose

Any thoughts ?

 

[bordan jarrett]

you don't need much more than screws for both, but you do need a lot of them.

cogs are cancer to work with.

 

[Deleted member 1078]

you don't need much more than screws for both, but you do need a lot of them.

cogs are cancer to work with.

Is the rule of thumb basically insert them above what you've lifting ?

so let's say i want to raise my eyebrow a bit in a specific place i insert a screw just above that place?

same for lips ?

 

[bordan jarrett]

Is the rule of thumb basically insert them above what you've lifting ?

so let's say i want to raise my eyebrow a bit in a specific place i insert a screw just above that place?

same for lips ?

more or less.

you can either put them inside or right above the lip, for the corners going inside is better.

 

[MUSTYCOPER]

more or less.

you can either put them inside or right above the lip, for the corners going inside is better.

so for lowering eyebrows and straighten them i would put them in from below the eyebrow