Madness
Inactive
- Joined
- Aug 22, 2018
- Posts
- 2,466
- Reputation
- 2,359
Here is the ultimate guide to mixing peptides
GHRP Peptides, CJC-1295 Peptides, HGH Frag 176-191 and IGF-1 Peptides.
You will need: peptide vial, syringe of 3ml, Sterilized water ampule and an alcohol damped pad or swab.
Step one: Remove The rubber stopper of peptide vial and clean it with the swab/pad then let it dry for a minute.
Step two: Open the water ampule and take out 2mls of water from the ampule. You need to turn the ampule upside down so that the syringe needle is facing the roof and flick the barrel to get air to the top.
Step three: push water to the tip of the needle to remove air and then shoot the water into the peptide container (hit the wall for better dilution). Make it sure that you release the pressure from the vial or it will burst, the best way to do this is after putting in your solution, twist off the pin top while its still in the vial, just for a split second is enough, then pull it out.
When drawing the solution out of peptide vial first fill the pin with air to the part you will be filling up to, then push air in, then draw peptide up to that same point, this keeps pressure even and makes drawing a bit easier
DO NOT SHAKE THE PEPTIDE ONLY RUB IT GENTLY.
Store at -4c
GHRP Peptides, CJC-1295 Peptides, HGH Frag 176-191 and IGF-1 Peptides.
You will need: peptide vial, syringe of 3ml, Sterilized water ampule and an alcohol damped pad or swab.
Step one: Remove The rubber stopper of peptide vial and clean it with the swab/pad then let it dry for a minute.
Step two: Open the water ampule and take out 2mls of water from the ampule. You need to turn the ampule upside down so that the syringe needle is facing the roof and flick the barrel to get air to the top.
Step three: push water to the tip of the needle to remove air and then shoot the water into the peptide container (hit the wall for better dilution). Make it sure that you release the pressure from the vial or it will burst, the best way to do this is after putting in your solution, twist off the pin top while its still in the vial, just for a split second is enough, then pull it out.
When drawing the solution out of peptide vial first fill the pin with air to the part you will be filling up to, then push air in, then draw peptide up to that same point, this keeps pressure even and makes drawing a bit easier
DO NOT SHAKE THE PEPTIDE ONLY RUB IT GENTLY.
Store at -4c